simplytriada.blogg.se - Flinto switches

FLINTO SWITCHES UPDATE

Flinto is a good tool for creating simple interactions and animations, but it falls short when confronted with more complex demands.

When accessing SwitchX via I2C or PCI, the -override_cache_replacement flag must be set. The -mac and -macs options are applicable only to Mellanox Technologies Ethernet adapter and switch devices. Non interactive mode - assume answer "yes" to all questions. Write this string, of up to 208 characters, to VSD when burn. Commands affected: burnĭo not save the ROM which exists in the device. Commands affected: burnīurn vsd as appears in the given image - do not keep existing VSD on flash. Commands affected: burnīurn (guids/uids/macs) as appears in the given image.

Save the ROM which exists in the device (FS3 and FS4 image only). GUIDs and MACs are derived from the given base UID according to Mellanox Methodologies. Use this flag to indicate that the given image file is in a "striped image" format.ĥth Generation (Group II) devices only. Running in this mode may cause the firmware to hang.ĭo not print burn progress flyer. NOTE: This flag is often referred to as -ocr NOTE: This flag is intended for advanced users only. Commands affected: allĪllow accessing the flash even if the cache replacement mode is enabled. Non interactive mode - assume answer "no" to all questions. NOTE: -mac/-macs flags are applicable only for Mellanox Technologies ethernet products. The specified MACs are assigned to port1, port2, respectively. 2 MACs are automatically assigned to the following values:Ģ MACs must be specified here. Prints the burning status to the specified log file NOTE: port2 guid must be specified even for a single port HCA.

The specified GUIDs are assigned to the following fields, repectively: node, port1, port2 and system image GUID. NOTE: port2 guid will be assigned even for a single port HCA - The HCA ignores this value.Ĥ GUIDs must be specified here. Guid -> node GUID guid+1 -> port1 guid+2 -> port2 guid+3 -> system image GUID 4 GUIDs are automatically assigned to the following values: num_of_flashes: the number of the flashes connected to the device.Type: The type of the flash, such as: M25PXxx, M25Pxx, SST25VFxx, W25QxxBV, W25Xxx, AT25DFxxx, S25FLXXXP.Use the given parameters to access the flash instead of reading them from the flash. Current default failsafe burn process burns a single image (in alternating locations). Make the burn process burn two images on flash (previously default algorithm). Exercise caution.ĭevice flash is connected to. NOTE: May result in system instability or flash corruption if the device or another application is currently using the flash. No command is allowed when this flag is used. Commands affected: burnįorce clear the flash semaphore on the device. These values can be set later using the "sg" command (see details below). Set the number of attached flash devices (banks)īurn the image with blank GUIDs and MACs (where applicable). Path to PEM formatted private key to be used by the sign commandĪccess to flash using FW (ConnectX-3/ConnectX-3Pro device only).

FLINTO SWITCHES UPDATE

UUID matching the given private key to be used by the sign commandĭo not attempt to work with the firmware Ctrl update commands. Path to the file containing the HMAC key (For FS4 image only).ĭo not attempt to take device data sections from device (sections will be taken from the image. Allows burning/removing a ROM to/from Firmware image when product version is present.